|
TI公司的TPS51650和TPS59650是集成了兩個柵極驅動器的雙路 VID全兼容的IMVP-7降壓控制器,支持CPU和GPU輸出,CPU通路具有一相,二相或三相,GPU通路具有一相或二相,8位 AC具有0.250V到1.52V的輸出,轉換電壓范圍3V到28V,主要用在IMVP-7 VCORE以及適配器,電池,NVDC或3V,5V和12V電源.本文介紹了TPS51650和TPS59650主要特性,方框圖,多種典型應用電路,以及TPS59650EVM-753評估模塊主要特性和指標,方框圖,電路,材料清單和PCB元件布局圖. The TPS51650 and TPS59650 are dual-channel, fully SVID compliant IMVP-7 step-down controllers with two integrated gate drivers. Advanced control features such as D-CAP+ architecture with overlapping pulse support (undershoot reduction, USR) and overshoot reduction (OSR) provide fast transient response, lowest output capacitance and high efficiency. All of these controllers also support single-phase operation for light loads. The full compliment of IMVP-7 I/O is integrated into the controllers including dual PGOOD signals, ALERT and VR_HOT. Adjustable control of VCORE slew rate and voltage positioning round out the IMVP-7 features. In addition, the controllers’ CPU channel includes two high-current FET gate drivers to drive high-side and low-side N-channel FETs with exceptionally high speed and low switching loss. TPS51650和TPS59650主要特性: Intel IMVP-7 Serial VID (SVID) Compliant Supports CPU and GPU Outputs CPU Channel One-Phase, Two-Phase, or Three-Phase One-Phase or Two-Phase GPU Channel Full IMVP-7 Mobile Feature Set Including Digital Current Monitor 8-Bit DAC with 0.250-V to 1.52-V Output Range Optimized Efficiency at Light and Heavy Loads VCORE Overshoot Reduction (OSR) VCORE Undershoot Reduction (USR) Accurate, Adjustable Voltage Positioning 8 Independent Frequency Selections per Channel (CPU/GPU Patent Pending AutoBalance™ Phase Balancing Selectable 8-Level Current Limit 3-V to 28-V Conversion Voltage Range Two Integrated Fast FET Drivers w/Integrated Boost FET Selectable Address (TPS59650 only) Small 6 × 6 , 48-Pin, QFN, PowerPAD Package TPS51650和TPS59650應用: IMVP-7 VCORE Applications for Adapter, Battery, NVDC or 3-V, 5-V, and 12-V Rails 
圖1.TPS51650和TPS59650方框圖
圖2.TPS51650帶電感DCR電流檢測的三相CPU,2相GPU應用電路圖
圖3.帶電感DCR電流檢測的一相GPU應用電路圖
圖4.帶電感DCR電流檢測的三相CPU應用電路圖
圖5.帶電感DCR電流檢測的2相CPU應用電路圖
圖6.帶電感DCR電流檢測的2相CPU和GPU不能的應用電路圖 TPS59650EVM-753評估模塊 The TPS59650EVM-753 is designed to use a 9V-20V Input bus to produce 6 regulated outputs for IMVP7 SVID CPU/GPU Power System. The TPS59650EVM-753 is specially designed to demonstrate the TPS59650 full IMVP7 mobile feature while providing GUI communication programing and a number of test points to evaluate the static and dynamic performance of TPS59650. TPS59650EVM-753評估模塊典型應用: • IMVP7 Vcore Applications for Adapter, Battery, NVDC or 3V/5V/12V rails TPS59650EVM-753評估模塊主要特性: • Complete solution for 9V-20V Input Intel IMVP7 SVID Power System • GUI communication to demonstrate full IMVP7 Mobile feature • 3-Phase CPU Vcore can support up to 94A output current • 2-Phase GPU Vcore can support up to 46A output current • 8 Selectable Switching frequency for CPU and GPU power • 8 Levels selectable current limit for CPU and GPU power • Switches or Jumpers for each output enable • On Board Dynamic Load for CPU, GPU Vcore and VCCIO output • High efficiency and high density by using TI power block MOSFET • Convenient test points for probing critical waveforms • Eight Layer PCB with 1oz copper SLUU896–
圖8.TPS59650EVM-753電源系統框圖
圖9.TPS59650EVM-753外形圖 TPS59650EVM-753電性能指標:
圖10.TPS59650EVM-753電路圖(1)
圖11.TPS59650EVM-753電路圖(2)
圖12.TPS59650EVM-753電路圖(3)
圖13.TPS59650EVM-753電路圖(4)
圖14.TPS59650EVM-753電路圖(5)
圖15.TPS59650EVM-753電路圖(6)
圖16.TPS59650EVM-753電路圖(7)
圖17.TPS59650EVM-753電路圖(8)
圖18.TPS59650EVM-753電路圖(9)
圖19.TPS59650EVM-753電路圖(10)
圖20.TPS59650EVM-753電路圖(11)
圖21.TPS59650EVM-753電路圖(12)
圖22.TPS59650EVM-753電路圖(13)
圖23.TPS59650EVM-753電路圖(14) TPS59650EVM-753材料清單:
圖24.TPS59650EVM-753 PCB元件布局圖:頂層
圖24.TPS59650EVM-753 PCB元件布局圖:底層 詳情請見: 
slusav7[1].pdf
(1.6 MB)
sluu896[1].pdf
(4.99 MB)
來源：網絡 |
